We are almost finished with the office remodel. We started by removing the paneling on the dinette side from the divider. It is held on with those long narrow staples. Half came our with the paneling and the rest stayed stuck in the 1 x 1 framing.
We removed the square drive screws that held the divider in the floor, wall and ceiling.
Then we had to remove the balusters as they created a lot of pressure and we could not pull the divider out of its location.
There were also two blind screws that were installed prior to the paneling being stapled in place behind the sofa. See the red circles.
Here is the dinette space with table and chairs out and before we installed the office desk / dining table along the exterior wall.
Here is the almost completed office desk in stalled. We will complete the desk with a finish or laminate tomorrow. We will also add a paper file / shelf underneath center of the desk to organize our printing paper and to provide support for the overall desk.
Tim and Mary
On the road in Michigan
No comments:
Post a Comment